Filter
Top Products
D 14049.01
07.2007
142
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Text goes here
Introduction
Getting
Started
System
Overview
System
Configuration
H.323 & SIP
Configuration
Registration
Control
Zones and
Neighbors
Call
Processing
Firewall
Traversal
Bandwidth
Control
Maintenance
Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Appendices
TANDBERG VIDEO COMMUNICATION SERVER
ADMINISTRATOR GUIDE
Appendices
Command Reference - xConguration
Zones
cont...
LocalZone
cont...
SubZone [1..100]
cont...
Bandwidth
cont....
Total Mode: <None/Limited/Unlimited>
Determines whether this subzone has a limit on the total bandwidth of calls being
used by its endpoints at any one time.
None: no bandwidth will be available.
Limited: there will be a limit on the bandwidth.
Unlimited: there will be no limit on the bandwidth.
Limit: <1..100000000>
(applies only if Mode is set to Limited)
Sets the total bandwidth limit (in kbps) of this subzone.
Name: <S: 1, 50>
Assigns a name to this subzone.
Subnet [1..5] IP Address: <S: 0, 39>
Species an IP address used (in conjunction with the IP Prex Length) to identify a subnet to be
assigned to this subzone.
PrexLength: <0..128>
Species the number of bits of the Subnet IP address which must match for an IP address to
belong in this subzone.
Traversal H323 Assent Mode: <On/Off>
Determines whether or not H.323 calls using Assent mode for rewall traversal will
be allowed. Applies to traversal-enabled endpoints registered directly with the VCS.
On: calls using Assent mode will be allowed.
Off: calls using Assent mode will not be allowed.
H46018 Mode: <On/Off>
Determines whether or not H.323 calls using H.460.18 mode for rewall traversal
will be allowed. Applies to traversal-enabled endpoints registered directly with the
VCS.
On: calls using H.460.18 mode will be allowed.
Off: calls using H.460.18 mode will not be allowed.
H46019 Demultiplexing Mode: <On/Off>
Determines whether the VCS will operate in Demultiplexing
mode for calls from traversal-enabled endpoints registered
directly with it.
On: allows use of the same two ports for all calls.
Off: Each call will use a separate pair of ports for media.