Filter
Top Products
1-7
Setting Up the Printer | 1-7
6. Close the clamp until it clicks into place. The corresponding
H
ink out
light goes out. Repeat steps 3 through 6 for the other ink cartridges.
7. Make sure all the
H
ink out lights are off, then close the ink
compartment doors. The printer begins charging the advanced ink
delivery system. The
P Operate
light flashes and the printer makes
various sounds.
Charging takes about 6 minutes. Do not turn off the printer or interrupt
this important process or you’ll use up more ink than necessary. The
P Operate
light stops flashing when the ink charging process is finished.
Loading Paper
Your EPSON Stylus Pro 5500 printer has four paper paths: one for the
standard paper tray, one for the optional lower paper cassette, and two for
the manual feed slots.
Follow these steps to load paper in one of the paper trays:
1. Pull the paper tray out until you feel some resistance. You can also pull
the tray all the way out of the printer to load paper.
Caution
Never turn off the printer
or open the paper path
cover on the back when
the
P
Operate light is
flashing. However, if the
light is still flashing after
15 minutes and the
printer is not moving or
making noise, you may
turn off the printer.
Note
See Chapter 2 for
instructions on using the
manual feed slots.