Filter
Top Products
1-16
1-16 | Setting Up the Printer
Connecting to an Optional Interface Card
The optional interface cards listed below let you use your printer on a
FireWire interface or a network. The Ethernet card automatically detects the
protocols on your network, so you can print from Windows 95, 98, Me,
2000, or NT 4.0, or a Macintosh on an AppleTalk network.
The following optional interface cards are available:
To install an optional interface card, follow these steps:
1. Turn off the printer and unplug the power cord from the electrical
outlet.
2. Disconnect any interface cables, if necessary.
3. Set any DIP switches and jumpers on the card, if necessary. See the
interface card’s documentation for details.
4. Use a Phillips screwdriver to remove the two screws securing the
optional interface cover, then lift off the cover. Keep the screws so you
can use them if you remove the interface card and replace the cover.
Note
Before you install an
optional interface card,
see the documentation
that comes with the card
for setup information.
Interface card Part number
10/100 BaseT Ethernet Type B interface card C823632A
IEEE-1394 FireWire Type B interface card C823722
Caution
Don’t install the interface
card when the printer is
connected to an electrical
outlet. Doing so may
damage the printer.