Filter
Top Products
1-17
Setting Up the Printer | 1-17
5. Slide the interface card along the slots inside the interface compartment.
Push it in firmly to fully insert the connector at the rear of the interface
card into the printer’s internal socket.
6. Secure the interface card with the two screws included with the card.
7. Connect a compatible interface cable to the interface card and to your
computer. If the cable has a ground wire, secure it as shown.
8. Plug in the printer’s power cord.
Now follow the steps in “Installing Printer Software for Windows” on
page 1-18 or “Installing Printer Software for Macintosh” on page 1-19 to
install the printer driver and utilities on your system.
If you use your printer on a network, also see “Setting Up Your Printer on a
Network” on page 1-21 for additional instructions.
Note
To remove an interface
card, follow the steps in
the reverse order.