Filter
Top Products
1-18
1-18 | Setting Up the Printer
Installing Printer Software for Windows
After connecting the printer to your computer, you need to install the
printer driver and utilities included on your printer software CD-ROM.
Follow these steps:
1. Make sure your printer is turned off.
2. Turn on your computer and start Windows. If the New Hardware
Found screen or Add New Hardware Wizard appears, click
Cancel
.
3. Insert the printer software CD-ROM in a CD-ROM or DVD drive.
After a moment, this dialog box appears:
4. Click
Install Printer Driver
, then click the icon.
5. Click
OK
in the next window to start printer software installation. You
see windows opening on your screen during driver installation. On
Windows 95 and NT, the Status Monitor 3 utility is also installed now.
6. Windows 95 or NT: Turn on your printer and go to step 7.
Windows 98, Me, or 2000: You see a window asking you to turn on
your printer. Press the
P
Operate
button until the
P
Operate
light
comes on. After a few moments, the software configures your printer
port and installs the Status Monitor 3 utility.
Note
If you’ll be using the
optional RIP software
drivers to control your
printer instead, see the
documentation on the RIP
software CD-ROM for
instructions on installing
and using the software.
click here
then click
here
Note
If you’re using Windows
2000 and connected your
printer with a parallel
cable or network interface
card, click the Stop
Searching button at
step 6 and go to step 7.