Filter
Top Products
1-18
DXC-D30WS/P(E)/V1
Chapter 2 Fitting and Connections
22
Chapter 2 Fitting and Connections
Fitting a VTR
1
Set the PRO 76-pin DIGITAL
connector on the DSR-1/1P.
For details, see the operating
instructions for the DSR-1/1P.
2
Align the projection on the
bottom of the DSR-1/1P with
the slot on the camera head.
3
Slide the DSR-1/1P and the
camera head together in the
groove as far as possible.
This section explains how to attach the DSR-1/1P to
the camera head. The method for attaching a PVV-3/
3P is similar.
When replacing the camera head grip with a camcorder
grip, see “Using the Camcorder Grip” (page 23).
Camera connector (PRO 76-pin DIGITAL)
DSR-1/1P
Projection
Slot
Groove
Camera head
(continued)
Chapter 2 Fitting and Connections
Chapter 2 Fitting and Connections
23
4
Tighten the two screws in the
grip connector and the two
screws in the shoulder pad
section.
Note
Slide the shoulder pad to its
central position before
tightening the screws.
Otherwise the screws may not
be properly fixed.
Screws
To remove the VTR
Reverse the fitting procedure.
To fit a camera adaptor
Follow the same procedure as when fitting a VTR.
Using the Camcorder Grip
camcorder grip and the method for attaching it differ
slightly depending on the type of VTR.
When using the camera head with a VTR as a
camcorder, you can replace the camera head’s grip
with a camcorder grip (not supplied). The type of
Attaching a camcorder grip to the DSR-1/1P
1
If the viewfinder is attached,
adjust the viewfinder to the
full-forward position.
For details, see “Adjusting the
viewfinder position” on page 28.
2
Remove the camera head
grip’s three screws, then pull
up the grip to remove it.
(continued)