Filter
Top Products
1-50
DXC-D30WS/P(E)/V1
86
Appendix
Appendix
Warning indications
Continuous
Flashing once per second
Flashing four times per second
Four beeps per second
One beep per second
Continuous
For the warnings appearing in the viewfinder when a VTR is connected, see the section “Viewfinder Normal Indications” (page
47).
Y/C separate signals
Warning Indications
If a fault occurs during operation, a warning is given
by the REC/TALLY and BATT indicators in the
viewfinder and the tally lamp lighting or flashing, and
also by warning indications on the viewfinder screen.
When you are using a DSR-1/1P or PVV-3/3P, the
WARNING indicator on the VTR also lights or
flashes, and warning indications appear in the display
window. There is also a warning tone in the earphone.
Camera
VTR
Fault VTR action What to do
REC/
TALLY
indicator
and tally
lamp
BATT
indicator
Viewfinder
screen
indication
WARNING
indicator
Display
window
Warning tone
—— RF
(during
recording
only)
(During
recording only)
The video
heads are
clogged, or
there is some
other fault in
the recording
system.
The VTR emits
a warning tone
when it detects
head clogging.
Carry out head cleaning,
referring to the instruction
manual for the VTR. If the
problem persists after cleaning
the heads, disconnect the
power and consult your Sony
dealer.
— — SERVO The servo
lock has
been lost.
Recording
continues, but
the recording
may not be
satisfactory.
Disconnect the power and
consult your Sony dealer. (The
SERVO indication may flash
momentarily when the tape
transport starts, but this does
not indicate a problem.)
— — HUMID
(During
recording)
(During
playback,
rewind, or fast
forward)
There is
condensation.
Recording
continues, but
if the tape
sticks to the
drum,
recording
stops.
Playback,
rewind, or fast
forward stops.
Stop the tape transport. Wait
until the HUMID indication
does not appear when you
power the unit on.
— — SLACK
The tape is
not wound
properly.
The operation
stops. (Refer
to the service
manual or
maintenance
manual.)
Press the EJECT button to
eject the cassette. Close the
cassette compartment and
check that the top panel has
descended before powering
off. Then consult your Sony
dealer. (Do not attempt to
insert any cassette.)
——
(During
recording
only)
TAPE
(flashing,
during
recording
only)
The tape is
near the end.
Operation
continues.
Change the cassette if
necessary.
— — TAPE
(flashing)
The tape is at
the end.
Recording,
playback, and
fast forward all
stop.
Change the cassette.
BATT
11.0V
BATT
(flashing)
(During
recording)
The battery is
almost
exhausted.
Operation
continues.
Change the battery when
possible.
BATT
10.5V
BATT
(flashing)
The battery is
exhausted.
Operation
continues.
Change the battery.
Appendix
87
Appendix
242 (9
5
/
8
)
Specifications
DXC-D30/D30P Camera Head
Imaging element Three-chip interline transfer CCD
Pixel resolution 768 (horizontal) × 494 (vertical)
(DXC-D30)
752 (horizontal) × 582 (vertical)
(DXC-D30P)
Imaging area 8.8 × 6.6 mm (corresponds to
2
/
3
-
inch picture tube)
Built-in filter settings
1: 3200K
2: 5600K +
1
/
8
ND
3: 5600K
4: 5600K +
1
/
64
ND
Lens mount Bayonet mount
Signal standards EIA standard signal (NTSC color
system) (DXC-D30)
CCIR standard signal (PAL color
system) (DXC-D30P)
Scanning system 525 lines, 2:1 interlace (DXC-D30)
625 lines, 2:1 interlace
(DXC-D30P)
Scanning frequencies
Horizontal:
15.734 kHz
(DXC-D30)
15.625 kHz (DXC-D30P)
Vertical: 59.94 Hz (DXC-D30)
50.00 Hz (DXC-D30P)
Synchronization Internal sync
External sync, using signal input
(VBS or BS) to the GEN LOCK
IN connector of an optional
camera adaptor or input from
the GEN LOCK connector of a
CCU-M5/M5P/M7/M7P camera
control unit to the VTR/CCU/
CMA connector of an optional
camera adaptor.
Horizontal resolution
850 TV lines (center)
Minimum illumination
0.5 lux (at f/1.4, +36 dB)
0.8 lux (at f/1.8, +36 dB)
Sensitivity 2000 lux (f/11.0 standard, 3200 K)
Gain levels Selectable –3 dB, 0 dB, 3 dB, 6 dB,
9 dB, 12 dB, 18 dB, 18 dB +
DPR, 24 dB, 24 dB + DPR, hyper
gain (30 dB + DPR)
Video output Composite signal
1.0 Vp-p, sync negative, 75 Ω,
unbalanced
Y: 1.0 Vp-p, sync negative,
unbalanced
C: burst level 0.286 Vp-p, no
sync
Video S/N ratio 63 dB (typical) (DXC-D30)
61 dB (typical) (DXC-D30P)
Registration 0.05% for all zones, without lens
Input/output connectors
VIDEO OUT connector: BNC,
75 Ω, unbalanced
LENS connector: 12-pin, for
2
/
3
-
inch lens
VF connector (front): 20-pin
VF connector (left side): 8-pin
REMOTE connector 1: Stereo
mini-jack
REMOTE connector 2: 10-pin
MONITOR OUT connector: BNC,
75 Ω, unbalanced
Power supply 12 V DC
Power consumption
12 W (12.7 W when the DSR1/1P
is connected)
Operating temperature
–10 °C to +45 °C (14 °F to 113 °F)
Storage temperature
–20 °C to +60 °C (–4 °F to 140 °F)
Mass 2.3 kg approx. (5 lb 1 oz)
External dimensions in millimeters (inches)
VCL-916BYA Zoom Lens
Focal length 9.0 to 144 mm
Zoom Manual or power, selectable; zoom
ratio: ×16
Maximum aperture
1:1.8
Iris Manual or automatic, selectable; f/
258
(10
1
/
4
)
480 (19)