Filter
Top Products
CGI Command Manual
100
EsAlmRec<ch>Time "<pre time>,<post time>" edgestorage edgestorage.cgi 1.10 It is time to record it.
EsAlmRecMaxTime<codec> "<pre time>,<post time>" edgestorage - 1.10 The maximum time when it can be specified is show.
EsSupportedAlm
"sensor<AI>"/"disconnected"/"vmf"/"
vmd"/"tampering"/"aud"
edgestorage -
1.10 The kind of the alarm is acquired.
Delete - edgestorage.cgi 1.10 All the data recorded with EdgeStorage function are deleted.
DeletebyName "<streamname>" - edgestorage.cgi
1.10 The data recorded with EdgeStorage are deleted with a
<streamname>.
Cond<n>
"<cond
type>,<cond1>,<cond2>,<duration>
"
eventconfig eventconfig.cgi
1.10 <n> is the integer of 1 - 2. The trigger of the alarm record is
established.
<cond type> : "and", "or" and "then" are specified in cond
type.
<cond1>,<cond2> : A detection factor ("sensor<AI>",
"detection", "tampering", "vmf", "aud", "disconnected") or
Cond<n> is specified.
<duration> : It is the time until the next event is accepted
after an event was detected. It is effective when "and" or
"then" is specified in cond type. Maximum setup time is
7200 seconds.
search - - -
1.10 It is the search of the record data. A form is as the following.
http://ipaddress/command/search?Order=<order>&Start=<start
>&End=<end>&MaxEntry=<max_entry>"
The Edge Storage CGI commands cannot be used with the following models.
♦ SNC-CH110/120/160/210/220/260
♦ SNC-DH110/110T/120/120T/140/140T/160/180/210/210T/220/220T/240/240T/260
♦ SNT-EP104/154
♦ SNT-EX154