Filter
Top Products
CGI Command Manual
48
RelativeZoom, SolidPTZ, SolidPTZ1, SolidPTZ2, SolidPTZMode, SolidPTZTiltDirection, VisiblePanRange, VisibleTiltRange
When a connected analog camera supports it, SNT-EX101/101E/104/154 can use the following CGI command.
♦ Move, Cancel, PanTiltMaxVelocity, ZoomMaxVelocity, AutoFlip
11.5 Focus/Zoom
Parameter Value InqParm SetCGI Ver Note
FzMove "<zoom>,<speed>" - focuszoom.cgi 1.00
The movement of a zoom of the lens is started.
<zoom>：”tele”/”wide”
FzMove "<focus>,<speed>" - focuszoom.cgi 1.00
The adjustment of the focus of the lens is started.
<focus>：”far”/”near”
FzMove "onepushaf,<speed>" - focuszoom.cgi 1.00 One push auto focus is begun.
FzMove "stop,<mode>" - focuszoom.cgi 1.00
A zoom or focus adjustment is stopped.
<mode>：”zoom”/”focus”
"zoom" ： A zoom movement is stopped. A focus stops when a focus follows a
zoom, too.
"focus" ： Focus adjustment is stopped. It doesn't stop when a focus follows a
zoom.
It is effective only in the movement by FzMove. A movement by the
FzAbsolute/FzRelative command doesn't stop.
FzInitialize "on" - focuszoom.cgi 1.00 A zoom and a focus are made condition in the factory default.
FzAbsoluteZoom "<zoom>" focuszoom focuszoom.cgi 1.00
It has a zoom in the position absolutely. A focus doesn't follow it.
<zoom>： 0 - 1599 ( Integer)
FzAbsoluteFocus "<focus>" focuszoom focuszoom.cgi 1.00
It is adjusted to the position to specify a focus.
<focus>：
・SNC-CH140/220/240/260/280： 0 – 899 ( Integer)