Filter
Top Products
CGI Command Manual
41
11.2 Exclusive camera control
Parameter Value InqParm SetCGI Ver Note
CamCtrlRight "on"/"off" system system.cgi 1.00 On or off the exclusive pan/tilt control from ActiveXviewer.
CamCtrlTime "10"to"600" system system.cgi 1.00
Set period of time in seconds. A client that has the permission of pan/tilt control
can control the camera in the period.
CamMaxWaitNo "0"to"10" system system.cgi 1.00 Set maximum number of the client who waits the exclusive control.
The Exclusive camera control CGI commands cannot be used with the following models.
♦ SNT-EP104/154
11.3 Date and time
Parameter Value InqParm SetCGI Ver Note
Time "<time>" system etc.cgi 1.00 Setting of local time.
GmTime "<time>" system etc.cgi 1.00 Setting of GM time.
TimeZone "<time zone>" system system.cgi 1.00 Setting of time zone.
DstMode "on"/"off" system system.cgi 1.00 Enable or disable summer time (daylight saving time).
DateFormat "ymd"/"mdy"/"dmy" system system.cgi 1.00 ymd : yyyy-mm-dd mdy : mm-dd-yyyy dmy : dd-mm-yyyy
NtpService "on"/"off" system system.cgi 1.00 Synchronization with NTP server
NtpSrvAdd "conf"/"dhcp"/"multi" system system.cgi 1.00
Setting of NTP server address,
conf : manual (max. 3)
dhcp : get from the DHCP/DHCPv6 server
multi : use multicast address
NtpServer "<server>" system system.cgi 1.00 Up to 64 characters.
NtpServer2 "<server>" system system.cgi 1.00 Up to 64 characters.
NtpServer3 "<server>" system system.cgi 1.00 Up to 64 characters.