Filter
Top Products
CGI Command Manual
114
12 Appendix
12.1 Image Size
The image size which can be chosen is shown in the table of the bottom. There may be a limitation in the
image size which can be chosen by the image 1 and the image 2. Furthermore, it may depend on setting
of maximum image size. Refer to a users' guide for the details.
The image size which can be set up with one Network Camera or Video Network Station at the
same time is two. SNC-RS44/46/84/86 can set up three ImageCodec's. It gives priority to the
setup of ImageSize1 and ImageSize2 in that case. The image size of ImageCodec3 is sometimes
changed to the value ImageCodec1 ImageCodec2 automatically.
Set up one of the image size in less than VGA (640x480). It gives priority to the setup of
ImageSize1. ImageSIze2 is sometimes changed to the VGA size automatically.
*1: It can use after the firmware Ver.1.10.
*2: It can be used in SNC-CH140 and SNC-DH140/180 since firmware ver1.10.
*3: It is the setting of the Maximum image size or the Aspect ratio.
*4: It can use after the firmware Ver.1.30.
Image Size
（width x height）
SNC-RS44N/46N/84N/86N
SNT-EX/EP Series
SNC-RS44P/46P/84P/86P
SNT-EX/EP Series
SNC-RH124/164
*3
(NTSC) (PAL) NTSC PAL
1280 x 720
1024 x 768
1024 x 576
800 x 600
*4 *4
800 x 480
768 x 576
720 x 576
*1
720 x 480
*1
704 x 576
*1 *1 *1 *1
640 x 480
640 x 368
384 x 288
352 x 288
320 x 240
320 x 192
176 x 144