Filter
Top Products
CGI Command Manual
103
♦ SNT-EP104/154
When a sound is reproduced with CH1, it is output in Audio Out in SNT-EX154. It isn't output in Audio Out even if a sound is reproduced with CH2 - CH4.
11.28 Alarm buffer
Parameter Value InqParm SetCGI Ver Note
AlmBufTime "<pre time>,<post time>" alarmbuffer alarmbuffer.cgi 1.00 Seconds
AlmBufMaxTime "<pre time>,<post time>" alarmbuffer - 1.00 Seconds
AlmBufMaxTime<codec> "<pre time>,<post time>" alarmbuffer - 1.00 Seconds
AlmBufCodec "jpeg"/"mpeg4"/ "h264" alarmbuffer alarmbuffer.cgi 1.00 A camera is rebooted when you change the setup of AlmBufCodec.
AlmBufInstance "image1","image2","image3" alarmbuffer alarmbuffer.cgi 1.00
The number of ImageCodec to store in the alarm buffer is specified. It is
ignored when the number which isn't being supported is specified. A still
picture is store when the number of ImageCodec which isn't working is
specified.
The Alarm buffer CGI commands cannot be used with the following models.
♦ SNC-CH110/120/160/210/220/260
♦ SNC-DH110/110T/120/120T/160/210/210T/220/220T/260
11.29 Object detection
Parameter Value InqParm SetCGI Ver Note
SuspenderAlarm "on"/"off" objectdetection objectdetection.cgi 1.00
In Moving Object Detection, alarm occurs also by pausing
objects.
EModStayTime "2"to"60" objectdetection objectdetection.cgi 1.00 In Moving Object Detection, hold time of pausing objects.
PositionMode "current"/"preset" objectdetection objectdetection.cgi 1.00 Return the current position mode.
ODPre<XXX>Mode "mod" objectdetection objectdetection.cgi 1.00 Moving Object Detection.