Filter
Top Products
CGI Command Manual
64
SNT-EP154 PrivacyPTZ<no.>, PrivacySetMask
SNT-EX101/101E PrivacyPTZ<no.> , PrivacySetMask
SNT-EX104 PrivacyPTZ<no.>, PrivacySetMask
SNT-EX154 PrivacyPTZ<no.>, PrivacySetMask
The Privacy mask CGI commands cannot be used with the following models.
♦ SNC-CH110/210
♦ SNC-DH110/110T/210/210T
11.8 Sense up
Parameter Value InqParm SetCGI Ver Note
DayNightMode
"auto"/"manual"/"timer"/"se
nsor"
camera camera.cgi 1.00
Select Day/Night mode. SNC-CH210 can set up only "auto"/" manual".
DnLevel "high"/"low" camera camera.cgi 1.00 The value which Day/Night is changed to is set up.
DnTime "2"/"30" camera camera.cgi 1.00
The time until it is changed after they become condition of switching of Day/Night is
specified.
DnSchedule <schedule> camera camera.cgi 1.00 Night mode time is set up when DayNightMode is "timer".
DnSensor<AI> "on"/"off" camera camera.cgi 1.00 Set to "on" when DayNightMode is set to "sensor".
DayNight "on"/"off" camera camera.cgi 1.00 Setup the schedule for Day/Night function. SNC-CH210 is always "off".
DnManualFunc "on"/"off" camera camera.cgi 1.00
The trigger.cgi can change Day/Night mode when this DnManualFund parameter is
"on" and DayNightMode parameter is not "auto".
DnStatus "on"/"off" camera - 1.00 Return the Day mode or Night mode.
DnSyncEasyFocus "on"/"off" camera camera.cgi 1.00 EasyFocus is executing out automatically at the time of switching of Day/Night.
IRLed "daynight"/“off" camera camera.cgi 1.00
When this is set up in "daynight", an IR irradiation function becomes on at the
"Night" time.