Filter
Top Products
CGI Command Manual
28
10 Information request command
This request is to be used for getting information such a result of motion detection or status of the sensor
input in the form of "HTTP bit stream".
Before using this command, you should configure as described below:
"AlamData" parameter in system.cgi is set to "on".
Configure motion object detection or unattended object detection if you need the information.
<Method>
GET
<Syntax>
http://ip_adrress/command/alarmdata.cgi
http://ip_adrress/command/alarmdata.cgi[?interval=<value>]
<Parameters>
interval=<value>
Parameter "interval" means interval seconds between the information is coming. The range of <value> is
from 0 to 3600. When 0 is specified the information is updated only when it changes.
<Example>
（Except SNT-EP104, SNT-EP154）
GET/command/alarmdata.cgiHTTP/1.1Host:
192.168.0.100 Connection: Keep-Alive
HTTP/1.0 200 OK¥r¥n
Content-Type: multipart/x-mixed-replace;boundary=--myboundary¥r¥n
¥r¥n
--myboundary¥r¥n
Content-Type: text/plain¥r¥n
CamTim: 2007-04-01 Sun 14:10:43¥r¥n
¥r¥n
Sensor1=0¥r¥n
Sensor2=0¥r¥n
Sensor3=0¥r¥n
Sensor4=0¥r¥n
OdWin1=0¥r¥n
OdWin2=0¥r¥n
OdWin3=0¥r¥n
OdWin4=0¥r¥n
VMF=0¥r¥n