Filter
Top Products
CGI Command Manual
42
11.4 Pan/Tilt/Zoom
Parameter Value InqParm SetCGI Ver Note
Move "<direction>,<speed>,<codec>" - ptzf.cgi 1.12
Move command in Pan/Tilt direction.
<direction>: left, right, up, down, up-left, up-right, down-left, down-right
<speed> : Network Camera : "1" to "24"
Video Network Station : "1" to "100"
Move "<zoom>,<speed>,<codec>" - ptzf.cgi 1.12
Move command in zoom direction.
<zoom> : tele, wide
<speed> : "1" to "8"
Move "<focus>,<speed>,<codec>" - ptzf.cgi 1.12
Move command in focus direction.
<focus> : near, far, onepushaf
（onepushaf is effective when FocusMode is manual. ）
<speed> : "1" to "8"
Move "stop,<mode>,<codec>" - ptzf.cgi 1.12
Stop command for moving.
<mode>:
"pantilt" or "motor": Stop panning and tilting.
"zoom": Zoom is stopped.
"focus": Focus is stopped.
AreaZoom
"<center X>,<center Y>,
<width>,<height>,<codec>"
- ptzf.cgi 1.00
width, height: 0 at DirectPT and PT Camera
<center X> : X distance from center (Pixel)
<center Y> : Y distance from center (Pixel)
<codec> : Video codec associated with distance
("image1"/"image2"/"image3")
Relative "<aabb>,<codec>" - ptzf.cgi 1.12 aabb: See chapter "8.1 relative parameter (syntax: relative=aabb)".
AbsolutePanTilt "<pan position>,<tilt position>,<speed>" ptzf ptzf.cgi 1.12 Move to specified address of pan and tilt. speed: "1" to "24"