Filter
Top Products
CGI Command Manual
30
11 CGI command list
These are the tables of every category of the CGI command. These CGI commands may not be able to be used by the model (see under the each table).
<codec> of Parameter is the integer (1 - 3) which shows ImageCodec1～ImageCodec3.
<codec> of Value is the string ("image1"/" image2"/" image3") which shows ImageCodec1～ImageCodec3. The models that <codec> can be specified in
Value are SNC-CH110/120/160/210/220/260 and SNC-DH110/110T/120/120T/160/210/210T/220/220T/260. When <codec> of Value is omitted, it is
equal to the case that "image1" was specified.（Even a model except for the above can use codec of Value for AreaZoom and EsRec.）
The CGI command that "Image1" or "Image2" has it about the end of Parameter controls that that ImageCodec1 or ImageCodec2. "Image1" of the end
can be omitted.
<AI > in the table CGI command shows the number of Alarm In. And, <AO> shows the number of Alarm Out. Refer to Appendix for the number which
can be used for every model.
11.1 System
Parameter Value InqParm SetCGI Ver Note
ModelName "<model name>" system - 1.00 Return the model name.
Serial "<serial no.>" system - 1.00 Return the serial number.
ChannelNum "1"/"4" system - 1.00
Return the number of channels (one channel or four channels) of
Video Network Station.
ChannelId "1"-"4" system - 1.00 Return the number of channels which VideoNetworkStation has.
RackModelName "SNT-RS1U"/"SNT-RS3U"
system - 1.10
The model name of the rack of Video Network Station is returned. It
can use only with SNT-EX154 and SNT-EP154.
RackSlotId "0" to "12"
system - 1.10
The slot ID of the rack of Video Network Station is returned. Value is
decimal number. "0" is the value of the unusual time. It can use only
with SNT-EX154 and SNT-EP154.
RackSerialNo "<rack serial no>"
system - 1.10
The serial number of the rack of Video Network Station is returned. It
can use only with SNT-EX154 and SNT-EP154.
PanTiltFunc "0"/"1" system - 1.00 Indicates the camera supports Pan/Tilt function. SNT-EP104 and