Filter
Top Products
Scan Using the Control Panel
118
6
(ADS-1500W)
a Type http://xxx.xxx.xxx.xxx (where xxx.xxx.xxx.xxx is the IP address of your machine) into your
browser.
You can configure or change the settings in Scan to FTP (for ADS-1000W) or Scan to FTP/Network (for
ADS-1500W) in the Scan tab. You can configure up to five FTP server profiles and choose what profile
numbers (1 to 5) to use for Scan to FTP settings in Scan to FTP Profile (for ADS-1000W) or Scan to
FTP/Network Profile (for ADS-1500W).
In addition to the seven preset file names you can store two user defined file names that can be used for
creating an FTP Server Profile.
Choose Scan to FTP (for ADS-1000W) or Scan to FTP/Network (for ADS-1500W) in Web Based
Management. In Create a User Defined File Name, enter a file name in one of the two user defined fields
and click Submit. A maximum of 15 characters can be entered in each of the user defined name fields (the
example below uses ADS-1500W).
NOTE
Do not use unsuitable characters in the file name (for example ?, /, \, or *). They may cause a sending error
when using Scan to FTP.
Configure the FTP Default Settings 6
You can set Passive Mode to Off or On depending on your FTP server and network firewall configuration.
By default this setting is On. You can also change the port number used to access the FTP server. The default
for this setting is port 21. In most cases these two settings can remain as the default (the example below uses
ADS-1500W).