Filter
Top Products
3-57
Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide
Compaq System Configuration Utility Pager Settings
for Booting into Compaq Utilities
Continued
Pager Data Setting Description
Dial-out status Enabled Allows ASR-2 to dial out to a remote workstation. If you selected this option,
Dial-In Status is automatically selected.
To use the dial-out feature, set Dial-Out Status to Enabled and set the Dial-Out
String to the correct phone number. You must also set the Reset Boot option to
Boot Compaq Utilities. When the system restarts because of an ASR reset, the
administrator is paged via Pager Status and Pager Dial String, the system
restarts to the Compaq Utilities, and dials out to the phone number provided in
the Dial-Out string. The dial-out number will be tried five times. If it fails to
connect after five attempts, the modem is put in auto-answer mode.
Dial-out string 555-1234 Enter the dial string followed by the remote computer telephone number.
Network status Enabled To allow network access to Compaq Utilities, set Network Status to Enabled
and make sure the Reset Boot option is set to Boot Compaq Utilities.
Network protocol To use IPX network access, set Network Protocol to IPX. When the system
restarts to the Compaq Utilities because of an ASR reset, it loads IPX network
support. This enables remote access via NVT.
To use IP network access, set Network protocol to IP. Also make sure to set
Network IP address, Network IP net mask, and Network IP router address.
When the system restarts to the Compaq Utilities because of an ASR reset, it
loads IP network support. This enables remote access via Telnet.
NOTE: The Network Status must be set to Enabled for network access.
Network controller Compaq For all Compaq Standard Network Controllers.
Network host
name
CPQHOU Enter the network name of the server. Use underscores instead of spaces
within the name, for example, Compaq_Server. If you are using IPX network
access to the Compaq Utilities, this server name is used to advertise NVT host
services. This server name displays in the Compaq Insight Manager server list
when it determines it can communicate via NVT. Set this name to be the same
as the server name you assign when the host OS is running.
Network card slot Slot # Select the slot number of the network interface card you wish to use for
network access to Compaq Utilities.
Network frame
type
ETHERNET_I I Select the frame type for your network. Selections include both Ethernet and
Token Ring topologies.
Continued