Filter
Top Products
2-1
Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide
Chapter 2
Removal and Replacement Procedures
This chapter provides subassembly/module-level removal and replacement procedures for
ProLiant 3000 Servers. After completing all necessary removal and replacement procedures,
run the Diagnostics program to verify that all components operate properly.
To service Compaq ProLiant 3000 Servers, the following tools are recommended:
■ Torx T-15 screwdriver
■ Torx T-25 screwdriver
■ Phillips screwdriver
■ From the Compaq SmartStart and Support Software CD:
❏ System Configuration Utility software
❏ Drive Array Advanced Diagnostics software
❏ Diagnostics software
Electrostatic Discharge Information
A discharge of static electricity can damage static-sensitive devices or microcircuitry. Proper
packaging and grounding techniques are necessary precautions to prevent damage. To prevent
electrostatic damage, observe the following precautions:
■ Transport products in static-safe containers such as conductive tubes, bags, or boxes.
■ Keep electrostatic-sensitive parts in their containers until they arrive at static- free
stations.
■ Cover workstations with approved static-dissipating material. Provide a wrist strap
connected to the work surface and properly grounded tools and equipment.
■ Keep work area free of non-conductive materials such as ordinary plastic assembly aids
and foam packing.
■ Make sure you are properly grounded when touching a static-sensitive component
or ssembly.
■ Avoid touching pins, leads, or circuitry.
■ Always place drives PCB assembly-side down.
■ Use conductive field service tools.