Filter
Top Products
3-39
Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide
DAAD Diagnostic Messages
Continued
Message Description Recommended Action
Configuration
signature is zero
DAAD detected that nonvolatile RAM
contains a configuration signature that is
zero. Old versions of the System
Configuration Utility could cause this.
Run the latest version of System Configuration Utility
to configure the controller and nonvolatile RAM.
Configuration
signature
mismatch
Array accelerator board configured for a
different array controller board.
Configuration signature on array
accelerator board does not match the one
stored on the array controller board.
To recognize the array accelerator board, run the
System Configuration Utility.
Controller
communication
failure occurred
Controller communication failure occurred. DAAD was unable to successfully issue commands to
the controller in this slot.
Controller
detected. NVRAM
configuration not
present
EISA nonvolatile RAM does not contain a
configuration for this controller.
Run the System Configuration Utility to configure the
nonvolatile RAM.
Controller
firmware needs
upgrading
Controller firmware is below the latest
recommended version.
Run Options ROMPaq to upgrade the controller to the
latest firmware revision.
Controller
firmware needs
upgrading (DAAD
Error 102)
Controller is correct, however, IDA
firmware version should be greater than
1.26.
Obtain the latest firmware.
Controller is
located in special
“video” slot
Controller is installed in slot for special
video control signals. If controller is used
in this slot, LED indicators on front panel
may not function properly.
Install the controller in a different slot and run the
System Configuration Utility to configure the
controller and nonvolatile RAM.
Controller is not
configured
Controller is not configured. If controller
was previously configured and you change
drive locations, there may be a problem
with placement of the drives. DAAD
examines each physical drive and looks
for drives that have been moved to a
different drive bay.
Look for messages indicating which drives have been
moved. If none appear and drive swapping did not
occur, run the System Configuration Utility to
configure the controller and nonvolatile RAM. Do not
run the System Configuration Utility if you believe
drive swapping has occurred.
Controller needs
replacing (DAAD
Error 102)
IDA firmware is less than version 0.96. Replace the controller as soon as possible.
Continued