Filter
Top Products
Index-7
Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide
error Continued
Accelerator status
Cache was automatically configured during
last controller reset. This can occur when
cacheboard is replaced with one of a
different size., description 3-38
Data in the cache was lost due to some
reason other than the battery being
discharged, description 3-37
Dirty data detected has reached limit. Cache
still enabled, but writes no longer being
posted, description 3-37
Dirty data detected. Unable to write dirty
data to drives, description 3-37
Excessive ECC errors detected in at least one
cache line. As a result, at least on cache
line is no longer in use, description 3-37
Obsolete data sensed at reset, description
3-37
Obsolete data was discarded, description
3-37
Obsolete data was written to drives,
description 3-37
Permanently disabled, description 3-36
Possible data loss in cache, description
3-36
Temporarily disabled, description 3-36
Unrecognized status, description 3-36
Valid data found at reset, description 3-38
Warranty alert, description 3-38
Adapter/NVRAM ID mismatch, description
3-38
ASR-2 detected by ROM 3-60, 3-61
ASR-2 Test Event 3-60, 3-61
Automatic Server Recovery Base Memory Parity
Error 3-60
Automatic Server Recovery Extended Memory
Parity Error 3-60
Automatic Server Recovery Memory Parity Error
3-60
Automatic Server Recovery Reset Limit Reached
3-60
Battery Failing 3-60
Battery X not fully charged, description 3-38
beeps, description 3-16
Board not attached, description 3-38
Caution
Temperature Exceeded 3-60, 3-61
Compatibility port problem detected, description
3-38
error
Continued
Configuration signature is zero, description
3-39
Configuration signature mismatch, description
3-39
Controller communication failure occurred,
description 3-39
Controller detected. NVRAM configuration not
present, description 3-39
Controller firmware needs upgrading (DAAD
Error 102), description 3-39
Controller firmware needs upgrading, description
3-39
Controller is located in special video slot,
description 3-39
Controller is not configured, description 3-39
Controller needs replacing (DAAD Error 102),
description 3-39
Controller needs replacing (DAAD Error 104),
description 3-40
Controller reported POST error. Error Code
x, description 3-40
Controller restarted with a signature of zero,
description 3-40
DAAD recorded errors attempting to access
X, description 3-40
Diagnostic Error 3-60
Disable command issued, description 3-40
Drive (bay) X firmware needs upgrading,
description 3-41
Drive (bay) X has insufficient capacity for its
configuration, description 3-41
Drive (bay) X has invalid M&P stamp,
description 3-41
Drive (bay) X has loose cable, description 3-41
Drive (bay) X is a replacement drive marked OK,
description 3-41
Drive (bay) X is a replacement drive, description
3-41
Drive (bay) X is failed, description 3-41
Drive (bay) X is undergoing drive recovery,
description 3-41
Drive (bay) X needs replacing (DAAD Error
102), description 3-40
Drive (bay) X RIS copy mismatch, description
3-41
Drive (bay) X upload code not readable,
description 3-41
Drive (bay) X was inadvertently replaced,
description 3-42