Filter
Top Products
3-13
Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide
POST Error Messages
Continued
Error Code
Audible Beeps
L=Long S=Short
Probable Source of Problem
Recommended Action
1787-Drive Array
Operating in Interim
Recovery Mode.
Physical drive
replacement needed:
Drive
X
None Hard drive
X
failed or cable is
loose or defective. Following a
system restart, this message
reminds you that drive
X
is
defective and fault tolerance is
being used.
1. Replace drive X as soon as
possible.
2. Check loose cables.
3. Replace defective cables.
*1788-Incorrect Drive
Replaced: Drive
X
Drive(s) were
incorrectly replaced:
Drive
Y
Select "F1" to
continue - drive array
will remain disabled.
Select "F2" to reset
configuration - all
data will be lost.
None Drives are not installed in their
original positions, so the drives
have been disabled.
See
note
below.
Reinstall the drives correctly as
indicated.
Press F1 to restart the computer with
the drive array disabled.
-Or-
Press F2 to use the drives as
configured and lose all the data on
them.
*NOTE: The 1788 error message might also be displayed inadvertently due to a bad power cable connection to the
drive or by noise on the data cable. If this message was due to a bad power cable connection, but not because of an
incorrect drive replacement, repair the connection and press F2.
-Or-
If this message was not due to a bad power cable connection, and no drive replacement took place, this could indicate
noise on the data cable. Check cable for proper routing.
Continued