Filter
Top Products
3-6 Diagnostic Tools
POST Error Messages
Continued
Error Code
Audible Beeps
L=Long S=Short
Probable Source of Problem
Recommended Action
201-Memory Error None RAM failure. Run Diagnostics. Replace failed
assembly as indicated.
203-Memory
Address Error
None RAM failure. Run Diagnostics. Replace failed
assembly as indicated.
205-Cache Memory
Error
None Cache memory error. Replace the processor board in the slot
indicated.
205-Option Cache
Memory Error
None Option cache memory error. Replace the option cache board.
206-Cache
Controller Error
None Cache controller failure. Run Diagnostics. Replace failed
assembly as indicated.
207-Invalid Memory
Configuration -
Check DIMM [SIMM]
Installation
None Memory module installed
incorrectly.
Verify placement of memory modules.
208-Invalid Memory
Speed - Check
DIMM [SIMM]
Installation
1L, 1S The speed of the memory is too
slow, where:
xx00 = expansion board SIMMs
are too slow, or
00yy = system board SIMMs
are too slow. xx and yy have
corresponding bit set.
The speed of the memory modules
must be 60 ns. Verify the speed of the
memory modules installed and replace.
210-Invalid Memory
Configuration
Detected. System
halted.
None Maximum amount of memory
exceeded.
Verify installed memory does not
exceed 1 GB.
211-Cache Switch
Set Incorrectly
None Switch not set properly during
installation or upgrade.
Verify switch settings.
212-System
Processor
Failed/Mapped out
1S Processor in slot x failed. Run Diagnostics and replace failed
processor.
213-Cache Size
Error
None Invalid optional cache size. Replace cache with 256K cache.
213-System
Processor Not
Installed
1S System processor configured
for slot indicated is missing.
Install processor in the slot indicated or
run the System Configuration Utility to
remove the processor from the.
CFG
file.
214-DC-DC
Converter Failed
None PowerSafe Module (DC-DC
Converter) failed.
Run Diagnostics. Replace failed
assembly as indicated.
Continued