Compaq 113803-001 Security Camera User Manual


 
3-15
Compaq ProLiant 3000 Servers, for use with Intel 350 MHz or greater processor-based servers only, Maintenance and Service Guide
POST Error Messages
Continued
Error Code
Audible Beeps
L=Long S=Short
Probable Source of Problem
Recommended Action
1793-Drive Array -
Array Accelerator
Battery Depleted -
Data Lost
(Error message 1794
also displays.)
None This indicates that while the
system was in use, power was
interrupted while data was in
the Array Accelerator memory.
Array Accelerator batteries
failed. Data in Array
Accelerator has been lost.
Power was not restored within eight to
ten days. Perform orderly system
shutdowns to avoid data remaining in
the Array Accelerator.
1794-Drive Array -
Array Accelerator
Battery Charge Low.
Array Accelerator is
temporarily disabled.
Array Accelerator will
be re-enabled when
battery reaches full
charge.
None This is a warning that the
battery charge is below 75%.
Posted-writes are disabled.
Replace the Array Accelerator board if
batteries do not recharge within 36
power-on hours.
1795-Drive Array -
Array Accelerator
Configuration Error.
Data does not
correspond to this
drive array. Array
Accelerator is
temporarily disabled.
None This indicates that while the
system was in use, power was
interrupted while data was in
the Array Accelerator memory.
The data stored in the Array
Accelerator does not
correspond to this drive array.
Match the Array Accelerator to the
correct drive array, or run the System
Configuration Utility to clear the data in
the Array Accelerator.
1796-Drive Array -
Array Accelerator Not
Responding.
Array Accelerator is
temporarily disabled.
None Array Accelerator is defective
or has been removed.
1. Check that the Array Accelerator
is properly seated.
2. Run the System Configuration
Utility to reconfigure the Compaq
IDA-2 without the Array
Accelerator.
1797-Drive Array -
Array Accelerator
Read Error Occurred.
Data in Array
Accelerator has been
lost. Array Accelerator
is disabled.
None Hard parity error while reading
data from posted-writes
memory.
Enable Array Accelerator.
Continued