Filter
Top Products
TIP: You may need two people to handle a large roll.
5. Slide the new roll onto the spindle. Make sure the paper type is oriented as shown. If it is not,
remove the roll, turn it 180 degrees and slide it back on to the spindle. There are labels on the
spindle showing the correct orientation.
NOTE: From the back of the printer, the blue stop is fitted onto the right-hand end of the spindle.
Ensure both ends of the roll are as close to the spindle stops as possible.
6. Put the blue paper stop onto the open end of the spindle, and push it towards the end of the roll.
7. Ensure the blue paper stop is pushed in as far as it goes, until both ends are against the stops.
If you are a regular user of different paper types, you can change rolls more quickly if you preload rolls
of different paper types on different spindles. Extra spindles are available for purchase, see
Accessories on page 101.
Load a roll into the printer
There are two ways to load a roll. The easy loading procedure is recommended.
To start these procedures you must have a roll loaded on the spindle. See
Load a roll onto the
spindle on page 23.
ENWW Load a roll into the printer 25
Paper handling