Filter
Top Products
Color calibration
Color calibration enables your printer to produce consistent colors with the particular printheads, inks
and paper type that you are using, and under your particular environmental conditions. After color
calibration, you can expect to get identical prints from any two different printers situated in different
geographical locations.
Calibration should be done in any of the following circumstances:
●
Whenever a printhead is replaced
●
Whenever a new paper type is introduced that has not yet been calibrated with the current set of
printheads
●
Whenever a certain amount of printing has been done since the last calibration
●
Whenever the printer has been turned off for a long period of time
●
Whenever the environmental conditions (temperature and humidity) change significantly
The printer driver usually reminds you with an alert whenever you need to perform color calibration,
unless you have disabled the alerts. However, there will be no alert if the environmental conditions
change.
You should calibrate a paper type before creating its color profile; however, you can later recalibrate
without needing to recreate the color profile.
You can turn off color calibration from the front panel: select the Image Quality Maintenance menu icon
, then set Enable color calibration to OFF. In this case, the printer will use a default calibration
set in the factory for all paper types. If you later turn color calibration back on, it will still remember any
calibrations that you performed earlier.
Check calibration status
You can check the color calibration status of the currently loaded paper at any time by pressing the
View loaded paper key on the front panel. The status may be one of the following:
●
PENDING: the paper has not been calibrated.
NOTE: Whenever you update the printer's firmware, the color calibration status of all papers is
reset to PENDING. See
Update the firmware on page 98.
●
OBSOLETE: the paper has been calibrated, but the calibration is now out of date for one of the
reasons mentioned above, and should be repeated.
●
OK: the paper has been calibrated, and the calibration is up to date.
●
N/A: this paper cannot be calibrated. The following paper types cannot be calibrated: plain paper,
transparent materials, and textured glossy paper (such as HP Collector Satin Canvas). They can,
however, be profiled.
Calibrate
You can start color calibration in the following ways:
●
From the printer driver alert that recommends calibration.
●
From the HP Color Center: select Paper Preset Management > Calibrate Paper.
●
From the front panel: select the Image Quality Maintenance menu icon
, then Calibrate
color.
60 Chapter 6 Color management ENWW
Color management