Panasonic AG-HPX250EN Camcorder User Manual


  Open as PDF
of 170
 
105
Editing
Connections to the DVCPRO/DV connector
Recording signals input to the
DVCPRO/DV connector
1 Connect a 1394 cable (DV cable).
•
“Precautionsin1394connections”(Page107)
•
Makesurethatthesignalformatofthe
camera-recorderandtheconnecteddeviceis
thesame.
2 To route inputs via the IEEE1394 interface,
set the menu option REC SIGNAL in the
SYSTEM SETUP screen to 1394.
•
TouseHD(1080i,720P)setthemenuoption
RECFORMATintheSYSTEMSETUP
screentoDVCPROHD/60i(DVCPRO
HD/50i)orDVCPROHD/60P(DVCPRO
HD/50P).
TheAVC-IntraformatandDVCPROHD
nativerecordingdonotallowinputviathe
IEEE1394interface.
3 Check that video from the IEEE 1394
interface is displayed in the viewnder or
LCD monitor, and press the START/STOP
button to begin recording.
4 Press the START/STOP button again to stop
recording.
•
Signals that have the same format as that
set in the menu options SYSTEM MODE
and REC FORMAT in the SYSTEM SETUP
screen should be input to the IEEE1394
interface. A signal in a different format will
not be correctly recorded on a P2 card.
Video and audio recording and EE type
video and audio of signal inputs other than
1x speed playback signals may not work.
·
“Errorsandwarnings”(Page126)
•
Audio signal inputs are input signals from
the DVCPRO/DV connector.
•
32 kHz/4CH (12 bit) audio signals input via
the IEEE1394 interface are recorded as
48 kHz/4CH (16 bit) on a P2 card.
•
It is not possible to use the GENLOCK IN
connector to synchronize to an external
reference signal.
•
Signals output from the VIDEO OUT
or AUDIO OUT connectors differ from
actual input signals. Use such signals for
monitoring.
•
The following functions do not operate.
·
Pre-recording function
·
Loop recording function
·
Interval recording and one-shot recording
function
·
One-clip recording function
•
As well as those displayed in blue, there
are other items on the setting menu for
which the setting value cannot be changed.
However, this is not a fault and these items
are not related to this function.
Time Code and User Bits
•
WheninputfromtheIEEE1394interfaceis
selected,thetimecodeanduser’sbitinputfrom
TCIN/OUTcannotberecordedonP2card.
•
WheninputfromtheIEEE1394interfaceis
selected,thetimecodeoutputfromTCIN/OUT
isnotsynchronizedwiththevideosignaloutput
fromtheVIDEOOUTterminal.
 previous next