Panasonic AG-HPX250EN Camcorder User Manual


  Open as PDF
of 170
 
63
Shooting
Entering the user bits
Theuserbitsallowinformation,includingmemos
thatuseuptoeight-digithexadecimalnumbers
(dateandtime),toberecordedintheSubcode
area.
COUNTER button
RESET button
Operation lever
MENU button
1 Open the setting menu RECORDING SETUP
screen and set the menu option UB MODE
to USER.
•
Fordetailsonmenuoperation,referto“Using
thesetupmenus”(Page28ofVol.1).
•
Youcanalsousethecorrespondingbuttons
ontheremotecontrol.Fordetails,see
“Descriptionofparts”(Remotecontrol).
(Page19ofVol.1)
2 Select CHANGE for UB PRESET on the
setting menu RECORDING SETUP screen
and press SET on the Operation lever to
open the User’s Bit setting screen.
3 Use Operation lever to set the user bits.
SEL : PUSH /
+/- : PUSH
0
0
0
0
0
0
0
0
UB PRESET
/
PRESET : PUSH SET
PUSH MENU TO RETURN
►direction: Shiftsthetarget(highlighted)
digittotheright.
◄direction: Shiftsthetarget(highlighted)
digittotheleft.
▲direction: Increasesthehighlightednumber
byone.
▼direction: Decreasesthehighlighted
numberbyone.
SET: Conrmsthesetuserbits.
•
PressingtheRESETbuttonwhilesettingthe
userbitswillresetanyuserbitsettingto0.
4 Press SET on the Operation lever and
conrm the user’s bit setting value and you
leave the user’s bit setting screen.
If you leave the user’s bit setting screen
without pressing SET on the Operation
lever, the set value is not retained.
5 Use the COUNTER button to display the UB
and conrm that the value set is displayed.
Retaining the user bits
Thedatasetfortheuserbitsareautomatically
savedandretainedevenifthevideocamera-
recorderisturnedoff.
 previous next