Panasonic AG-HPX250EN Camcorder User Manual


  Open as PDF
of 170
 
111
Editing
Using a hard disk drive (PC mode: USB host)
Inthismode,itispossibletoconnecttoaharddisk
drive(HDD),storecarddata(EXPORT):Referto
“Writingdataonaharddiskdrive”(Page115),view
thumbnailsofstoredclips(EXPLORE):Referto
“Viewingharddiskdriveinformation”(Page112),and
writedatabacktoP2cards(IMPORT):Referto
“WritingdatabacktoP2cards”(Page116).
Switching to the USB HOST mode
1 Select USB HOST in PC MODE SELECT on
the setting menu SYSTEM SETUP screen,
and press SET on the Operation lever.
•
Refertothesection“Usingthesetupmenus”
(Page28ofVol.1)formenuoperation.
PUSH MENU TO RETURN
REC FORMAT
CAMERA MODE
ASPECT CONV
SETUP
PC MODE SELECT
SCAN REVERSE
CAMERA
DVCPROHD/60i
24PA
OFF
LETTER BOX
REC SIGNAL
1080-59.9iSYSTEM MODE
SYSTEM SETUP
USB HOST
USB DEVICE
2 Press MENU twice to exit the menus.
3 Turn the POWER/MODE switch to the MODE
position to illuminate the PB/THUMBNAIL
lamp, and then turn and hold it.
•
ThePClampilluminates,thecameraenters
PCmode,anditgoestothethumbnail
screen.
•
Whenaharddiskdriveisconnected,the
HDDindicationintheupperrightcorner
staysilluminated.However,ifthisindicator
illuminatesred,itmeansthattheharddisk
driveisnotinausablestate.Conrmthe
HDDtype/state.
USBHOSTdisplay
•
In USB HOST mode, clips on P2 cards can
be displayed but video from the camera-
recorder or an external device cannot be
recorded.
Clips written to a hard disk must be written
back to a P2 card before it can be played
back.
·
“WritingdatabacktoP2cards”(Page116)
•
You cannot return to standard mode from
USB HOST mode. Turn the power off and
then turn it back on again.
 previous next