41
Shooting
2-slot continuous recording
IfyouinserttwoP2cardsintothetwocardslots,
thisfunctionallowsyoutorecordcontinuouslyon
thetwocards.
Youcanalsorecordcontinuouslyonthreeormore
cardsbyreplacingonecardwhiledataisbeing
recordedontheother.(Hotswaprecording)
However,dependingonwhentheP2cardis
insertedintoanemptyslot(immediatelyafter
prerecording,orbeforeoraftercontinuous
recordingspanningtwoslots),theremaybea
delayinrecognizingtheP2card.
WerecommendinsertingtheP2cardwhilethere
isatleastoneminuteremainingonthecardthatis
recording.
Youcanchangetheslotforrecordingwithone
touchifyoupressaUSERbuttontowhichthe
SLOTSELhasbeenallocated.
•
“UsingtheUSERbuttons”(Page39)
•
Youcannotchangeslotswhilerecordingsodo
thisduringrecordingstandby.
•
Doesnotsupporthotswapplayback.
Shot mark function
Themarksattachedtothethumbnailsofclips
arecalledshotmarks.Onthethumbnailscreen
monitoryoucanselectonlythoseclipswithashot
markanddisplaythemorplaythemback.
•
“Switchingthethumbnaildisplay”(Page80)
Duringrecording,whenyoupresstheUSERbutton
towhichtheSHOTMARKfunctionhasbeen
allocated,MARKONappearsintheLCDmonitor
ortheviewnder,andashotmarkissetforthe
thumbnailoftheclipbeingrecorded.Ifyoupress
thebuttonagain,theshotmarkisreleased.
•
“UsingtheUSERbuttons”(Page39)
•
A shot mark added during a pause after
recording is added to the most recently
recorded clip.
•
Shot marks can be added also in the
thumbnail display.
•
The shot mark function is not available
during loop recording, interval recording
and one-shot recording. When this function
is not available, pressing this button
displays SHOT MARK INVALID.
•
Shot marks can be set or cancelled in
playback pause mode but not during
playback.
•
Shot marks cannot be set or deleted for
video data created in a single hot-swap
recording session consisting of multiple
clips unless all the P2 cards that contain
the video data for the entire session are
inserted. In clips that consist of multiple
clips like the one above, shot marks can be
added only to the rst clip of video data.