Filter
Top Products
Chapter 4 Adjustments and Settings for Recording4-82
4
DCC FUNCTION SEL: Specifies either the activation of the DCC or
a knee fixed at D Range 600% when the DCC is selected. Select
FIX if you don’t want too sharp a change in image contrast.
VTR MODE: Enables the REC switch on the camcorder and the
REC switch on an external VTR to function independently
when the camcorder is connected to the external VTR via the
TRIAX connector on a CA-702/702P.
REC INHIBIT (CCU): The VTR section on the camcorder and the 5-
inch viewfinder (or color viewfinder) cannot be used while the
camcorder is connected to a camera control unit via the TRIAX
connector on a CA-755. If you are using a 5-inch viewfinder (or
color viewfinder), turn REC INHIBIT (CCU) to ON. If you want
to record using the VTR section, turn the REC INHIBIT (CCU) to
OFF.
Note
When the camera control unit is connected to the camcorder, the
playback and rec review functions cannot be used.
ASSIGNABLE SW: Sets the functions assigned to the
ASSIGNABLE button on the side of the camcorder.
OFF: Disables the button.
ATW: Assigns the auto-tracing white balance function.
RET: Assigns the return function.
REC: Assigns the VTR START function (page 2-25).
TURBO: Assigns the turbo gain function (page 2-20).
AUDIO: Displays the audio mode on the viewfinder screen.
LOOPR: (This setting is possible only when the BKDW-703 is
installed.) Assigns the Loop Rec mode ON or OFF function.
When the Loop Rec time is set to OFF on the OPERATION 2
page, pressing the button alternately selects Loop Rec time 4
and OFF. If the Loop Rec time is set to something other than
OFF on the OPERATION 2 page, then pressing the button
will toggle the setting between the selected Loop Rec time
and OFF.