Filter
Top Products
Chapter 4 Adjustments and Settings for Recording4-124
4
Setting the card ID
When data is written to a setup card, it is useful to set an ID for the card
to identify it.
When data is saved to a card, a card ID is written to the card together
with the data. When data is read from a card, the card ID is also read, and
that ID overwrites the card ID associated with the data that was
previously in the camcorder.
1 Move the cursor to ID EDIT on the SETUP CARD page.
2 Press the rotary encoder.
The currently set card ID appears. If no card ID is currently set, 10
spaces (s) appear. The cursor is at the left-most character or space.
3 Turn the rotary encoder clockwise as seen from the front of the
camera until the character you wish to set appears.
The character display cycles from the alphabet, through the symbols,
and the digits in that order. Turn the rotary encoder
counterclockwise to cycle through the characters in the reverse
direction.
Currently set card ID,
or 10 spaces
E11*SETUP CARD
READ(pCAM)
WRITE(pCARD)
pID EDIT
WRITEPROTECT:OFF
WHITE DATA : OFF
o
ID:
READ? (Y:PRESS)