Filter
Top Products
Chapter 5 Setting Up the Camcorder 5-43
5
When connecting the remote control unit to the
camcorder
• The OUTPUT/DCC switch, GAIN switch, AUTO W/B BAL switch,
SHUTTER switch, and the MENU ON/OFF/PAGE switch and so forth
will not function.
• When you connect the remote control unit, the camcorder will return to
the settings that were in effect the last time you used the remote control
unit.
For more details, refer to “maintenance manual.”
When removing the remote control unit from the
camcorder
The setting of the camcorder changes to the setting before you connected
the remote control unit.
By setting the DIP switch inside the camcorder, the setting of the paint
adjustment on the remote control unit can be stored (except the setting of
the camcorder by the camcorder’s switch)
Note
You can use a setup card to store the camcorder settings before you
connect the remote control unit. This will allow you to restore those
settings at later time, even if you make changes on the remote control
unit and save those changes using the DIP switch in the camcorder.
After disconnecting the remote control unit, you can restore the original
settings by reading them from the setup card.
For more details, refer to “maintenance manual.”