Filter
Top Products
Chapter 4 Adjustments and Settings for Recording 4-11
4
If you have no time to adjust the white balance
DVW-709WS/709WSP/790WS/790WSP
For automatic adjustment of the white balance, set the WHITE BAL
switch to PRST, then the FILTER selector to B for 3200 K, to C for
4300 K, or to D for 6300 K.
DVW-707/707P
Set the WHITE BAL switch to PRST. The white balance is
automatically set to 3200 K when the FILTER selector is in position 1,
and to 5600 K in other positions.
For details about setting the white balance manually, see section 4-1-2 “Adjust the
White Balance ”(page 4-5).
White balance memory
Values stored in memory are held until the white balance is next
adjusted.
There are two sets of white balance memories, A and B, and adjustments
for each of the filters can be automatically stored in the memory
corresponding to the setting (A or B) of the WHITE BAL switch. The
camcorder has four built-in filters, so a total of eight (4 × 2) adjustments
can be stored. The number of memories allocated each A and B can be
limited to one each by setting FILTER INH. to ON on the FUNCTION
2/2 page of the setup menu. In this case, the memory contents are not
linked to the filters.
When the WHITE BAL switch is set to B whereas, in the setup menu
OPERATION 1 page, “WHITE B” is set to ATW, the ATW function is
activated to automatically adjust the white balance of the picture being
shot for varying lighting conditions.