Filter
Top Products
Chapter 2 Installing the Cisco IPICS Server Software
Installing Cisco IPICS Server Software
2-42
Cisco IPICS Server Installation Guide
OL-8155-01
• Upgrade—This option installs an upgrade to a previously installed version of
Cisco IPICS server software
Figure 2-29 Install Set Options
Step 9 To choose the Typical option, press Enter.
Note If you decide not to install CSA with this installation of Cisco IPICS
server software, you can manually install CSA at a later time. For more
information, see the “Manually Installing CSA” section on page 2-46. For
information about manually uninstalling CSA, “Uninstalling CSA”
section on page 5-7.
The installer prompts you to enter a new password for the root user.
Step 10 Enter a root password that is at least six characters in length. Then, press Enter.
Caution When you enter your new root user password, make sure that you only use
passwords that begin with a-z, A-Z or 0-9. Cisco IPICS does not support the use
of special characters as the first character in the root password. If you enter a
special character as the first character in the root password, your root login will
become inoperable and you will need to boot the system in the single user mode
to change the root password and reinstall Cisco IPICS to resolve the problem.
For information about single user mode and changing the root password, see
Appendix A, “Changing the Cisco Linux Root Password.”
The installer prompts you to re-enter the root password.
Step 11 Enter the root password again and press Enter.