Filter
Top Products
2-47
Cisco IPICS Server Installation Guide
OL-8155-01
Chapter 2 Installing the Cisco IPICS Server Software
Preparing to Use Cisco IPICS
[root tmp] #tar xvf /root/CSAStandAlone.tar
Step 6 Navigate to the /CSCOcsa directory by entering the following command:
[root tmp] #cd CSCOcsa
Step 7 To install the CSA software, enter the following command:
[root CSCOcsa] #sh install_rpm.sh
Step 8 Enter the following command to restart the server and complete the installation:
[root] #reboot
For information about manually uninstalling CSA, see the “Uninstalling CSA”
section on page 5-7.
Preparing to Use Cisco IPICS
Now that you have completed the Cisco IPICS installation, complete the
following tasks, so that you can begin using the software:
• Checking the Installation, page 2-47
• Managing Your Licenses, page 2-49
• Generating the Cisco IPICS PMC Application Installer, page 2-58
For information on other Cisco IPICS setup and configuration tasks, refer to the
Cisco IPICS Server Administration Guide.
Checking the Installation
When you complete the Cisco IPICS server software installation, you should be
able to access the Cisco IPICS Administration Console by using a browser. You
can test the installation by opening a browser and logging in to the Administration
Console.
Note There may be a delay of a few minutes before users can access the
Administration Console after the Cisco IPICS server restarts.