Filter
Top Products
136
HP Photosmart R717 User’s Manual
Resetting the Camera
If your camera does not respond when you press any
buttons, try resetting the camera as follows:
1. Turn off the camera.
2. If you have an optional memory card installed, remove it.
(Although removing an optional memory card is not
necessary for performing the reset, it eliminates the
memory card as a possible cause of the problem.)
3. Remove the battery from the camera, and make sure the
HP AC power adapter is not connected to the camera.
4. The Reset switch is in the small
hole located above the battery
slot, as shown. Press the
straightened end of a paper
clip into the Reset switch until
the switch is depressed, and
hold it down for approximately
three seconds, then remove the
paper clip. The camera is now
reset.
5. Reinsert the battery and close the Battery/Memory card
door.
6. After verifying that the camera works without an optional
memory card, reinsert the card if you removed one in
Step 2.
Resetting the camera returns all settings to their factory
defaults. Images stored in memory or on an optional memory
card are retained.