Filter
Top Products
60
HP Photosmart R717 User’s Manual
Using the Burst Setting
Burst allows you to take 2 or 3 pictures (depending on the
shutter speed) as quickly as possible when you press the
Shutter button all the way down. Pressing the Shutter button
all the way down again takes another sequence of 2 or 3
pictures.
1. Press the Timer/Burst button until Burst
appears in the Image Display.
2. Frame the subject and press the Shutter button halfway
down to lock the focus and exposure. Then press the
Shutter button all the way down and hold it. The camera
takes up to 3 pictures as quickly as possible until you
release the Shutter button or the camera runs out of
memory.
The Image Display remains off during the burst capture. After
the burst pictures have been taken, each image appears one
at a time on the Image Display.
When Burst is selected, the Burst icon will appear in the
Live View screen. The Burst setting remains in effect until it is
changed again, or until it resets to the default Normal timer/
burst setting when you turn the camera off. To save changed
settings, use My Mode (see page 55).
NOTE: The Burst setting is not available while recording
video clips, in Panorama or Document shooting modes,
nor when you are using AE Bracketing. You also cannot
record audio when using the Burst setting, but you can
add an audio clip later (see Record Audio on page 103).
Also, the flash is not available while using the Burst
setting.