Filter
Top Products
140
Autoplay
This feature automatically cycles through the card’s recorded stills one after another, in
the same order that they were taken. This is a convenient way to quickly review all of
the stills in the card.
You can start autoplay only when you are displaying a shot that was recorded as a still
image. This feature is not available if you are viewing a movie frame (if you see the
mark on the monitor).
For details about how to use the menu, see “Using the Playback
menu” on page 139.
Select SLOW to display images for 15 seconds
each.
Select FAST to display images for 2 seconds
each.
To stop autoplay...
Press the MENU button ( ). Note that the camera will continue cycling through
images until you do this. (If the camera is powered by batteries only, however, it will
automatically stop autoplay and enter standby mode after about 30 minutes.)
CHANGE
END
[
FAST
]
Select from menu...
Select to go to the
autoplay selection screen.
OK
ENTER
BACK
SLOW
FAST
Select the operation...