Filter
Top Products
195
Appendix
The card in the camera is protected by a write-protect seal.
➔
If you’re absolutely sure you wish to write to this card, remove (and discard) the
seal (p.32). Otherwise use a different card.
No card in camera.
➔
Insert a card. (p.32)
The camera isn’t in RECORD mode.
➔
Turn the mode dial to . (p.42)
The flash doesn’t fire.
The scene has enough light without the flash.
➔
If you wish to force the flash regardless of ambient light conditions, set the flash
mode to “fill-in.” (p.87)
The camera is set for sequence shooting or panorama shooting.
➔
The flash is automatically disabled when you are shooting sequences or
panoramas. (pp.119, 131)
The flash mode is set to “off.”
➔
Change to a different flash mode. (p.84)
Images do not play back on the monitor.
The camera is still in RECORD mode.
➔
Set the mode dial to PLAY mode ( ).
The card is empty.
➔
The monitor displays the “NO PICTURES” message to let you know that the card is
empty (p.62). Take some pictures, then try again.
There’s a problem with the card.
➔
Refer to “Error Messages” on page 200 for more information.
The camera is connected to a TV.
➔
The monitor does not operate if a video cable is connected to the video output jack.
(p.70)