Filter
Top Products
199
Camera Does Not Print
The camera does not eject the film at all, or the film stops before fully ejecting.
➔
Press the PRINT button ( ) again to eject the jammed film. If all goes well, the
camera will eject either one or two film sheets.* Check carefully to see whether the
print results are as expected.
The film remains jammed even after the PRINT button was pressed a second time.
➔
Replace the film pack. The camera will eject the jammed film together with the new
pack’s cover sheet. (pp.34–37, 59)
The film is jammed in such a way that the film pack cannot be replaced.
➔
Bring the camera in for service.
*If the film ejects only one sheet, the remaining film count (displayed on the monitor)
may no longer match the actual amount of film remaining in the pack.
Appendix
Troubleshooting (continued)
CAUTION
• Do not try to forcibly pull out film that is stuck partially emerged from the print outlet.
Forcing the film may break the mechanism.