Hasselblad H1D Digital Camera User Manual


 
152
153
Hasselblad H1D
Hasselblad H1D
The H1D can be used together with most ash units. Connection is either by the PC socket or by
the hot shoe if the unit is compatible (see note below).
The viewnder houses an integral ll-ash with a guide number of 12 and features OTF/TTL
ash control. This unit is capable of providing enough illumination for simple indoor shots at
shorter distances as well as many ll ash functions outdoors. Flash output can be adjusted
separately from ambient exposure for optimum control. Separate ash units can be used in
dedicated mode when connected to the hot shoe if the unit is compatible with the SCA3002
(Metz) system using a Hasselblad SCA3902 adapter. This provides a cable free link up for in-
formation transfer.
Automatic ash works equally well with digital capture as well as lm backs.
Flash synchronisation can be set to normal or rear (the beginning or end of an exposure).
Please see the relevant user manuals for information regarding separate ash units.
! As with all strobe/studio ash use, very particular attention should be taken to ensure cor-
rect connections and general handling practice. Potential dangers might increase when
cameras are also connected to electronic peripherals (computers, lighting units, etc) and
should diminish when IR and similar wireless ash release devices are used. Victor Hasselblad
AB can accept no responsibility whatsoever for accidents that might occur when Hasselblad
equipment is used in combination with third-party units of any description.
General
When an automatic TTL ash unit is attached, the H1D automatically takes into account
whether the sensor unit is in place or whether a lm magazine has been tted, as the camera