Filter
Top Products
154
155
Hasselblad H1D
Example of viewnder LCD display showing
Flash set to Rear sync as well as - 1EV exposure
compensation.
Hasselblad H1D
To change the balance between ash output and camera exposure requirements to produce a
variety of eects, use the exposure compensation function. For various long exposure eects
use the sync function. To make ash exposure tests use the ash measure function.
To access the controls:
1) Activate the camera and press the FLASH button once.
2) Turn the front control wheel to set the amount of compensation required:
• from +3EV through -3EV (amount dependent on ISO value
)
3) Turn the rear control wheel to set:
• normal sync (ash triggered just after the shutter opens)
• rear sync (ash triggered just before the shutter closes)
• ash measure (with non-TTL ash units or TTL units in Manual mode)
4) The grip LCD shows the ash mode - Normal or Rear - in the standard display. However,
when set to Flash Measure, a specic screen requests you to press the AE-L button in
order to make a reading.
Integral ash
The integral ash unit features the following specications:
Guide no. 12
Coverage 56º horizontal, 44º vertical
Maximum light fall-o at side centres - 1EV (50%)
Colour temperature (full ash) 5,000 – 5,600º K
4