Filter
Top Products
156
157
Hasselblad H1D
Hasselblad H1D
holder (if SCA3902 compatible) on the top of the viewnder or via
a cord to the PC connection port on the le hand side of the camera
body. Slave unit switches/ transmitters can also be connected similarly
dependant on unit (see specic user manuals for details).
Keep the plastic safety cover in place in the hot shoe when not in
use.
Flash measure
You can measure the eect of an attached ash unit (with PC con-
nected ash units and SCA3902 compatible ash units set to M mode),
where the camera acts much as a ash meter would. By choosing
‘Flash measure’, a trial exposure is made with the auxiliary shutter
still in place which therefore prevents lm frames from being used.
e aperture setting can be adjusted and more trial exposures made
until the information on the grip LCD is satisfactory.
To use ash measure:
1) Press the FLASH button on the grip once to access the ash
option screen.
2) Turn the rear control wheel until Flash measure appears.
3) Press the DRIVE/Save button to access the ash exposure
screen.
4) Make preliminary required aperture setting.
5) Press the AE-L button. The camera will close the aperture, raise
the mirror and re the ash. Light reected from the ash lit sub-
ject will be reected o a white spot on the auxiliary shutter to
the meter sensor.
6) Deviations from a normal exposure are displayed as dierences
in EV on the grip LCD and the viewnder LCD. If ‘high’ or ‘low’
appears, change the aperture accordingly and make a new test
reading.
7) Change the aperture until Di EV: 0 appears, or the desired
amount of deviation from the normal exposure.
Lo signies more than 2 EV under
Hi signies more than 2 EV over