Filter
Top Products
80
81
Hasselblad H1D
Hasselblad H1D
by unscrewing it in a counter-clockwise direction. Align the index on the lens with the index
on the camera body and rotate the lens clockwise (bayonet tting) until it clicks into place.
Removing a lens
Depress the lens release button and keep it depressed while rotating the lens counter-clock-
wise until it stops and li it out. Replace protective caps on the lens immediately and on the
camera body if necessary.
If you try to rotate the lens before you press the lens release button, it might lock. In this case,
rotate the lens clockwise a little rst and then re-attempt removal with the correct procedure:
button rst, then lens.
Front lens cap
Front lens caps are released for removal and attachment by inserting a thumb and index
nger into the recesses and pinching in the direction of the arrows.
Filters
Filters have a screw thread tting (67 / 77 / 95 mm, according to lens) and are screwed clock-
wise into place. As there is no rotation of the front section of the lens when focus is changed,
lters do not rotate either. is is particularly useful when using polarizing or graduated
lters where the orientation is normally critical.
Lens shades
All lenses are supplied with lens shades that additionally provide extra protection for trans-
port and storage when mounted in reverse. Lens shades have a bayonet tting and are turned