Filter
Top Products
114 Notices
Important Safety Instructions
Before using your printer, read the following safety instructions to make sure you use the printer safely
and effectively:
■ Be sure to follow all warnings and instructions marked on the printer.
■ Use only the type of power source indicated on the printer’s label.
■ Connect all equipment to properly grounded power outlets. Avoid using outlets on the same
circuit as photocopiers or air control systems that regularly switch on and off.
■ Place the printer near a wall outlet where the plug can be easily unplugged.
Placez l’imprimante près d’une prise de contacte où la fiche peut être débranchée facilement.
■ Do not let the power cord become damaged or frayed.
■ If you use an extension cord with the printer, make sure the total ampere rating of the devices
plugged into the extension cord does not exceed the cord’s ampere rating. Also, make sure the total
ampere rating of all devices plugged into the wall outlet does not exceed the wall outlet’s ampere
rating.
■ Keep your printer and computer system away from potential sources of electromagnetic
interference, such as loudspeakers or cordless telephone base units.
■ Avoid locations that are subject to rapid changes in heat or humidity, shocks or vibrations, or dust.
■ Leave enough room around the printer for sufficient ventilation.
■ Do not place the printer near a radiator or heating vent or in direct sunlight.
■ Place the printer on a flat, stable surface that extends beyond the printer base in all directions. The
printer will not operate properly if it is tilted or at an angle.
■ Turn off and unplug the printer before cleaning. Clean with a damp cloth only. Do not spill liquid
on the printer.
■ Use a soft, dry cloth only to clean the display and preview monitor. Do not use liquid or chemical
cleaners on these parts.
■ Always leave the cover on the preview monitor slot, unless you are using the preview monitor.
■ Always turn the printer off using the P power button. It may take a moment for the printer to
shut off after you press the button. Don’t switch off the power strip or unplug the printer until the
printer is off.
■ Do not block or cover the openings in the printer’s case or insert objects through the slots.
■ Except as specifically explained in this manual, do not attempt to service the printer yourself.
■ Do not remove a memory card or turn off the printer while the computer and card are
communicating (when the light next to the card is flashing). Doing so can corrupt files on the
memory card.
Pbasics.book Page 114 Tuesday, June 1, 2004 1:31 PM