Filter
Top Products
179
Specifications
Appendix
Video S/N ratio 54 dB (Y-typical)
Modulation 800 TV lines
Geometric distortion
None identified (excluding distortion due
to lens)
Smear –120 dB (Y-typical)
LCD Picture: 8.9 cm (2
1
/
2
inches) in opposite
angle (3.5 type)
Pixel resolution: 25,000 pixels (1120
wide × 224 high)
Effective picture elements: more than
99.99%
DXF-20W Viewfinder
Picture tube 2-inch, aspect ratio 16:9, monochrome
Indicators REC (×2), TALLY, BATT,
SHUTTER, GAIN UP
Resolution 600 lines
Power voltage 12V DC
Power consumption
3 W
Mass Approx. 620 g (1 lb 5 oz)
Maximum dimensions
239 × 76 × 215 mm (9
1
/
2
× 3 × 8
1
/
2
inches) (
w/h/d)
Stereo microphone
Type Back electret condenser microphone
Directivity Super cardioid
Frequency response
100 Hz to 20 kHz
Output impedance
100 Ω
Power voltage 48 V DC
Mass Approx. 120 g (4 oz)
Dimensions 162 × 21 mm (6
1
/
2
×
27
/
32
inches) (length
× diameter) (excluding cable)
Optical Disc Drive Section
Video characteristics
Sampling frequency
Y: 74.25 MHz
P
B
/P
R
: 37.125 MHz
Quantization 8 bits/sample
Compression MPEG-2 MP@HL
DVCAM
Audio characteristics
Sampling frequency
48 kHz
Quantization 16-bit/2-channel, 16-bit/4-channel
Headroom 20/18/16/12 dB (selectable)
Frequency response
20 Hz to 20 kHz +0.5 dB/–1.0 dB (0 dB,
1kHz)
Dynamic range More than 85 dB
Distortion Max. 0.08 % (1 kHz)
Input/output connectors
Signal inputs
AUDIO IN CH-1/CH-2
XLR type, 3-pin, female
–60 dBu, –50 dB, –40 dBu/+4 dBu
(0 dBu = 0.775 Vrms)
MIC IN XLR type, 5-pin, female, –50 dBu
GENLOCK IN BNC type, 1.0 Vp-p, 75 Ω, unbalanced
TC IN BNC type, 0.5 V to 18 Vp-p, 10 kΩ
Signal outputs
AUDIO OUT CH-1/CH-2
XLR type, 5-pin, male, +4 dBu, 600 Ω
VIDEO OUT (composite)
BNC type, 1.0 Vp-p, 75 Ω, unbalanced
SDI OUT BNC type, SMPTE 292M, SMPTE 259M
TC OUT BNC type, 1.0 Vp-p, 75 Ω
EARPHONE (mini jack)
8 Ω, – ∞ to –15 dBs variable
Others
DC IN XLR type, 4-pin, male, 11 to 17 V DC
DC OUT 4-pin, 11 to 17 V DC, maximum rated
current 0.2 A
LENS 12-pin
REMOTE 8-pin
LIGHT
1)
2-pin
i.LINK 6-pin, complies with IEEE 1394
1) The accessory fitting shoe which you can use to attach a video light to this
unit is of the
1
/
4
-inch tapped hole type. If you want to replace this with a
slide-type shoe, contact your Sony dealer.
Pin assignment of the connectors
DC IN connector (4-pin, male)
Pin number Signal Standard
1 EXT DC IN (G) GND
2– –
3– –
4 EXT DC IN (X) +11 to +17 V DC
1
2
3
4