Filter
Top Products
72
Recording – Advanced Operations
Chapter 3 Recording and Playback
5
When you have finished entering the prefix, turn the
MENU knob to move the x mark to END, and then
press the MENU knob.
The camcorder exits prefix input mode, and the
original CLIP TITLE page appears.
To set the initial value of the clip title serial
number
You can set the initial value of the clip title serial number
to 00001 (default) or to any five-digit value.
To return the initial value to 00001
Proceed as follows.
1
On the CLIP TITLE page, select “CLEAR
NUMERIC” and then press the MENU knob.
The message “CLEAR OK? YES b NO” appears.
2
Select YES and then press the MENU knob.
The value in the “NUMERIC” field returns to “00001”
(default).
To set the initial value to any number
Proceed as follows.
1
On the CLIP TITLE page, select “NUMERIC” and
then press the MENU knob.
A digit selection screen appears.
2
Move the x mark to the digit you want to change and
then press the MENU knob.
3
Turn the MENU knob to move the x mark to the
desired digit in the list of selectable digits, and then
press the MENU knob.
4
Repeat steps 2 and 3 to enter the remaining digits.
5
When you have finished entering the value, turn the
MENU knob to move the x mark to END, and then
press the MENU knob.
The camcorder exits numeric input mode, and the
original CLIP TITLE page appears.
To check the titles of recorded clips
Press the THUMBNAIL button to display the thumbnail
screen, and then select the clip whose title you want to
check.
The title of the selected clip appears in the upper left of the
screen.
See “Cuing up with sub clip thumbnails” (page 82) for
more information about the thumbnail screen.
• It is not possible to specify 00000 as the initial value.
Even if you enter 00000, the value is reset to 00001 when
the camcorder exits numeric input mode.
• The value of the serial number is incremented by 1 every
time a title is generated. When the value reaches 99999,
the next number restarts from 00001.
• Duplicate clip titles can be generated if you reset the
serial number after recording several clips or the same is
true depending on the value setting. Care should be taken
when setting the serial number.
Assigning User-Defined Clip and
Clip List Names
The following standard format names are assigned
automatically to clips and clip lists that are created or
recorded by XDCAM devices.
Clips: C0001 to C0300
Clip lists: E0001E01 to E0099E01
You can use the supplied PDZ-1 Proxy Browsing Software
to assign user-defined names instead of the standard
format names. Assigning meaningful names to clips and
clip lists can facilitate file management. You can also use
this unit’s “AUTO TITLING” function to assign user-
defined names to clips.
To assign clip names on this unit
The title assigned to clip becomes its clip name (file
name).
005 CLIP TITLE
0123456789
INS DEL RET ESC END
CLEAR NUMERIC : EXEC
LOAD PREFIX DATA: EXEC
PREFIX : EXEC
NUMERIC : EXEC
Notes
C0001.MXF
TITLE00001
When sub item “AUTO NAMING” is set to “C****”