Filter
Top Products
Transferring clips (Direct FTP function)
143
Chapter 5 Operations in GUI Screens
6 Select the remote host (the target device
to which you want to transfer the clips).
You can register up to four remote hosts.
Remote Host 1 to 3: Register these in the
settings screen.
Remote Host 4(UPnP): A remote host that
supports UPnP (universal plug and play)
is detected and registered automatically
(see “To enable the UPnP function”
(page 142)).
To check remote hosts discovered by the
UPnP function
Select “Hosts Discovered via UPnP”, and
then press the SET/S.SEL button or the
MENU knob. (If the UPnP function of this
unit is disabled, a confirmation screen
appears prompting you to enable it. Select
“OK” and then press the SET/S.SEL button
or the MENU knob.
The Select Host Discovered via UPnP screen
appears. (Some time may be required before
the search for remote hosts finishes.)
Select the name of a remote host from the list,
and press the SET/S.SEL button or the
MENU knob. A network settings screen
appears (see step 7). If you establish a
connection with the selected remote host, the
network settings are saved in Remote Host 4.
From the next time that you select “Remote
Host 4(UPnP)”, the remote host that you
select here will be connected.
To check the network settings of this unit
Select “Network Config”, and then press the
SET/S.SEL button or the MENU knob. The
following network settings appear.
a) An IP address determined by a DHCP server
appears instantly in this field.
Select OK and press the SET/S.SEL button
or the MENU knob to return to the previous
screen.
7 Select ,, and then press the SET/
S.SEL button or the MENU knob.
A network settings screen for the remote host
appears.
Item Setting
Host Name Host name
IP Address
IP address
a)
Subnet Mask Subnet mask
DHCP Setting that specifies
whether to acquire the IP
address automatically from
a DHCP server
Enabled: Acquire
automatically
Disabled: Do not acquire
automatically
Address Status Method used to set IP
address
Manual Set: Manually
DHCP: DHCP function
AutoIP: Auto IP addressing
function
Undefined: Nothing
specified
Default Gateway Default gateway
Item Setting
Host Name Host name or IP address. (If
this is a host name, a DNS
server must be available on the
connected network.
Specification of an IP address
is recommended.)
Port Port used by the FTP server
(normally “21”).