Filter
Top Products
Menu List
186
Chapter 6 Menu Displays and Detailed Settings
22/23 NETWORK DHCP ENABLE/
DISABLE
Selects whether to enable automatic acquisition of
the IP address from a DHCP server.
Notes
• IP address, subnet mask, default gateway, and DNS
server 1 and 2 cannot be set when DHCP is set to
“ENABLE”.
• To check automatically acquired settings, close the
menu and open it again.
IP ADDRESS xxx.xxx.xxx.xxx
192.168.1.10
Set the IP address of this unit.
SUBNET MASK xxx.xxx.xxx.xxx
255.255.255.0
Sets the subnet mask.
DEF.GATEWAY xxx.xxx.xxx.xxx
0.0.0.0
Set the address of the default gateway.
LINK SPEED AUTO/10Mbps/
100Mbps
Sets the communications speed.
DUPLEX AUTO/FULL/
HALF
Sets the duplex mode.
DNS1 xxx.xxx.xxx.xxx
0.0.0.0
Set the address of DNS server 1.
DNS2 xxx.xxx.xxx.xxx
0.0.0.0
Set the address of DNS server 2.
UPnP DISABLE/
ENABL
Select whether to enable the UPnP (universal plug
and play) function.
DISABLE: Disable the UPnP function.
ENABLE: Enable the UPnP function.
NET CFG RESET EXEC Reset network settings to the factory defaults.
23/24 UP
CONVERT
ER
UP CON
PROCESS
FIELD/ADPT Selects the conversion source picture when SD is
upconverted to HD.
FIELD: Use the field picture.
ADPT: Optimize the ratio of conversion from the
frame or field picture.
UC DETAIL
LEVEL
(–99 to 99) Adjusts the sharpness of edge enhancement by the
upconverter.
UC CRISPENING (–8 to 7) Sets the amplitude width at which the upconverter
does not emphasize low-amplitude signals.
UC DETAIL
LIMIT
(–99 to 99) Sets the maximum level of edge enhancement by
the upconverter.
UC LV DEPEND
LV L
(–8 to 7) Sets the luminance of edge enhancement by the
upconverter.
UC DTL
FREQUENCY
3.2M/4.5M/
5.0M/4.0M
Sets the center frequency and frequency
properties of edge enhancement by the
upconverter.
3.2M: 3.2 ± 1.1 MHz
4.5M: 4.5 ± 1.4 MHz
5.0M: 5.0 ± 0.7 MHz
4.0M: 4.0 ± 2.0 MHz
UC DTL H/V
RATIO
(–3 to 4) Sets the horizontal/vertical ratio of edge
enhancement by the upconverter.
No. Page Item Settings Description